Service manual

48
• Printer test works, but printer does not print when attached to computer
Check Possible remedy
Printer cable has a problem. Make sure that the printer cable is correctly
connected at both ends, printer and com-
puter.
Problem with the application Refer to your application program manual.
program.
Check Possible remedy
Your software is overriding Set your printer in Font/Pitch lock. See
your control panel selection. “Pitch lock mode” and “Font lock mode” in
Chapter 4.
Check Possible remedy
This might indicate an error Check the status of the control panel indi-
or normal operation. cators and see “Conditions indicated by beep
tones” in Chapter 4.
• Printer sounds the audible alarm
• Pitch or font selected is being changed
• Printer does not feed paper
Check Possible remedy
Paper is jamming. Remove all forms and pieces of paper.
Bail lever is closed before pa- Open the bail lever.
per goes through the bail lever
location.
Adjustment lever is set incor- Check the setting of the adjustment lever.
rectly. See “Adjusting the printing gap” in Chapter
3.
Fanfold form is parked. Move bail lever forward to unpark the
fanfold paper.