Service manual

44
Switch B-5: Printable area
This printer can use two types of printing area format.
By putting the switch ON (“Type A”), the top of the first line of printing
will start 1/6 inch from the top of the paper, and the printed area will
end 1/6 inch from the bottom of the paper.
By putting the switch OFF (“Type B”), the first line of printing will
start at one inch from the top of the paper, and the printed area will
end to print 6 mm from the bottom of the printer.
Switches C-1 and C-2: Print Mode
These switches select the default print pitch and the fonts as shown
bellow.
Page Length C-3 C-4 C-5
11 inches/Letter ON ON ON
8 inches OFF ON ON
11.7 inches/A4 ON OFF ON
12 inches OFF OFF ON
8.5 inches ON ON OFF
14 inches/Legal OFF ON OFF
10.5 inches/Executive ON OFF OFF
7.25 inches OFF OFF OFF
Print Mode C-1 C-2
10CPI DRAFT ON ON
17CPI DRAFT OFF ON
10CPI LQ OFF OFF
NOTE: If you change these swiches after you have saved a macro,
these new settings will override the macro setting.
Switches C-3 to C-5: Page Length
Leave these switches ON if you will be using 11-inch forms. You will
need to change the switches if you will be using a different page length
as shown below:
Switch D-1: Character Table
Move this switch OFF to select Italic character table. If you leave this
switch to the ON position, in place of italics you will get the graphic
characters, international characters, and mathematical symbols.