Service manual

41
C hapter 5
DEFAULT SETTINGS-EDS MODE
From the control panel you can change the parameters that define how your
printer works. These parameters become your power-on settings. This function
is called the Electronic DIP Switch (EDS) mode.
HOW TO SET THE EDS MODE
The EDS mode in this printer has 13 functions that you can set as the power-
on default.
Turn the printer on while simultaneously holding the FONT, PITCH, and
PAPER FEED buttons. You will hear an acknowledging beep as power
comes on. This indicates that you have entered the EDS mode.
In EDS mode, the buttons on the control panel are used as shown below in
Figure 5-1.
Figure 5-1. Button functions in the EDS mode.
• Use the FONT button to select the Bank Letter.
• Use the PITCH button to select the Switch Number.
• The ON LINE indicator shows the current setting, ON or OFF.
Use the ON LINE button to change the settings.
• Press the PAPER FEED button to print the current settings.
• Press the PITCH button while holding down the FONT button to save
and exit the EDS mode.