Service manual

36
1. Press the ON LINE button to set the printer off-line.
2. Press the FONT button and hold it down.
3. While holding the FONT button down, press the PAPER FEED button.
The paper will be fed out backward.
Top of form
When you power on the printer, the top-of-form position is automatically set
to the current position. If this is not where you want the top of the page to be,
you can change the top-of-form positon as follows:
1. Press the ON LINE button to set the printer off-line.
2. Move the paper to the desired top-of-form position by pressing the PAPER
FEED button, or by performing a forward or reverse micro-feed.
3. Press and hold the ON LINE button.
4. While holding the ON LNE button down, press the FONT button, then
release both buttons at the same time. The top-of-form position has been set.
Forward micro-feed
For fine alighnment, you can feed the paper forward in very small increments
as follows:
1. Press the ON LINE button to set the printer off-line.
2. Press the ON LINE button again and hold it down.
3. While holding the ON LINE button down, press the PAPER FEED
button.The paper will start advancing in a series of small steps.
When you want to stop, release both buttons.
Reverse micro-feed
You can also feed the paper in small increments in reverse, to return to a
higher position on the same page.
1. Press the ON LINE button to set the printer off-line.
2. Press the ON LINE button again and hold it down.
3. While holding the ON LINE button down, press the PITCH button. The
paper will start moving backwards in a series of small steps.
When you want to stop, release both buttons.
NOTE:Open the bail lever when the printer beeps intermittently near the
edge of the paper.