Service manual

SWITCH COMBINATION FUNCTIONS

Several additional functions can be achieved by pressing the control panel

buttons in combinations.

Figure 4-5.

Switch combination functions of control panel.

Form feed

If you are using cut forms, this operation ejects the current page. If you are

using fanfold forms, it feeds to the top of the next page.

1. Press the ON LINE button to set the printer off-line.

2. Press the PAPER FEED button and hold it down. The printer will start

performing successive line feeds.

3. While holding the PAPER FEED button down, press the ON LINE button,

then release both buttons at the same time. The printer will smoothly eject

the current page.

Paper parking

This procedure feeds the paper backward. It parks the fanfold form at the

back of the printer so that you can switch to single-sheet feeding (by moving

the release lever to the down position).

Before parking fanfold forms, tear off all but the last page, leaving less (at

least three inches less) than a full page showing above the front cover.