Service manual

Figure 3-9.

Tear off the printed fanfold paper.

4. Press the PAPER FEED button while holding the FONT button on the

control panel.

The printer will automatically feed the fanfold form backward until the

paper is completely free of the platen.

5. The POWER indicator on the control panel will blink and a beep will

sound.

6. Move the release lever toward the rear of the printer ( ).

7. Mount the paper guide in the upright position.

Now you can load single sheets. The fanfold paper remains parked at the

back of the printer.

Paper unparking

When you want to resume using fanfold paper, the procedure is as follows.

1. Remove all cut forms from the printer.

2. Mount the paper guide in the horizontal position.

3. Move the release lever toward the front of the printer ( ).

4. Move the bail lever forward. The printer will automatically feed the parked

fanfold paper back into position for printing.

NOTE: The printer beeps intermittently if you move the release lever while

the paper is loaded.