Service manual

21
Figure 3-6. Adjust the tractor positions to accommodate the width of fanfold forms.
9. Close the rear cover, then set the paper guide in the horizontal position,
as shown in Figure 3-7. This will separate the printed from the unprinted
paper.
8. Now close the tractor covers, again making sure that the paper holes are
aligned with the pins on the tractor units. If they are not aligned properly,
you will have problems with paper feeding, possibly resulting in tearing
and jamming of the paper.
Figure 3-7. Close the rear cover, then set the paper guide horizontally.
10.Turn on the power using the switch located at the front of the printer. The
printer will beep, indicating that the paper is not yet fully loaded. The
POWER indicator will also flash on the control panel to confirm this.