Service manual

20
4. Open the rear cover using the two grips on either side, as in Figure 3-4.
Figure 3-4. Opening the rear cover.
5. Pass the paper between the printer case and the rear cover.
6. Open both tractor covers and mount the paper by aligning holes with the
pins on the tractor unit.
Figure 3-5. Mount the fanfold paper over the tractor units.
7. Adjust the spacing of the tractor units by sliding them along the bar,
using the clamp lever at the back of each unit to release and lock them in
position. When the clamp lever is down, the unit is released, and when it
is up, the unit is locked.