Service manual

19
LOADING FANFOLD FORMS
This printer accepts fanfold forms up to 10” wide.
This printer can feed fanfold forms from the rear of the printer, as shown in
Figure 3-3.
Figure 3-3. Paper path for fanfold forms.
This section will take you through the procedures for loading, parking and
unparking fanfold forms.
1. Place a stack of fanfold paper behind and below the printer.
2. Turn the printer’s power OFF.
3. Pull the release lever toward the front of the printer ( ). This has the
effect of releasing the paper from the platen roller, and engaging the tractor
feed.