Service manual

Federal Communications Commission
Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Unauthorized modifications of this product by the user will void his authority to operate the
equipment unless expressly approved by the party responsible for compliance.
For compliance with the Federal Noise Interference Standard, this equipment requires a
shielded cable.
The above statement applies only to printers marketed in the U.S.A.
Statement of
The Canadian Department of Communications
Radio Interference Regulations
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian Department
of Communications.
The above statement applies only to printers marketed in Canada.
Trademark Acknowledgements
NX-2440, NX-2430, NX-2420, NX-2410, SF-10DV, SPC-8K: Star Micronics Co., Ltd.
IBM-PC, PS/2, PC-AT, PC-DOS: International Business Machines Corp.
MS-DOS, Microsoft BASIC, Windows: Microsoft Corporation
LQ-860, LQ-850: Seiko Epson Corp.
NOTICE
All rights reserved. Reproduction of any part of this manual in any form whatsoever
without STAR’s express permission is forbidden.
The contents of this manual are subject to change without notice.
All efforts have been made to ensure the accuracy of the contents of this manual at the
time of press.
However, shoulld any errors be detected, STAR would greatly appreciate being
informed of them.
The above notwithstanding, STAR can assume no responsibility for any errors in this manual.