Instruction manual

MFJ-1289 Multicom User's Manual Page 4
Before Installing Your Multicom Software
If you haven't already done so, be sure of the following:
o Your controller is connected to the power supply.
o The RS-232 cable is connected between your controller and your
computer.
o Your radio is properly interfaced to the controller's RADIO 1 or RADIO
2 port (or the single radio port of the MFJ-1270, 1270B or 1274).
Check the Fast-Start manual included with your MFJ-1278B or other controller,
to make sure that the controller and radio are properly hooked up.
Once you're sure that the MFJ-1278B is properly interfaced with your computer,
you are ready to begin installing the software for use.
Note: The MFJ Multicom software (MULTICOM.EXE, found on Disk #1) is
copy-protected. If your computer does not have a hard disk, you must use
the original floppy disk supplied by MFJ when operating Multicom.