Instruction manual

MFJ-1289 Multicom User's Manual Page 37
Using the Function Buffers
To use one of the function buffers, follow these steps:
1. Make sure your TNC is in "command mode" (with a cmd: prompt
showing) on your terminal mode screen.
2. Press <F6> to access the function buffer screen.
3. Choose the mode in which you want to operate from the list at the top of
your screen, then press the appropriate function key (i.e., if you wanted
to work in AMTOR mode, you would press the <F2> key to access the
AMTOR function buffer, with all of its associated "slots").
4. When you have chosen the correct function buffer, choose which "slot" to
send to your TNC by pressing the "slot" number. In the example in step 3
above, pressing the number 2 key would switch the TNC into AMTOR's
"listen" mode.