Instruction manual

MFJ-1289 Multicom User's Manual Page 28
Function Keys in Multicom;
Each of these keys may be pressed directly. More complete descriptions of
several functions listed are found later in this manual:
<F1> Sends a hex 03 (equivalent to a <Ctrl> + C) to your controller.
This places the controller into the "command" mode and gives
you a cmd: prompt. You can press it three times in succession
to escape the "transparent" mode." Use this key to switch you
from "converse" mode and to allow the controller to receive your
instructions. While in "command" mode, nothing is sent over the
air.
<F2> Sends the "converse" command to the TNC. This is the opposite
of the "command" mode; whatever you type following this will be
transmitted over the air. Use this key to stop giving commands to
your controller, and "converse" with your contact on the air.
<F3> Places you into the program "configure" screen. Although you
have already configured your system and saved the parameters
to disk, you may wish to go back and change them later. Use this
key for that purpose.
<F4> Enter the multi-level FAX system. For details on FAX operation,
see the "Multi-Level Fax" chapter on page XX.
<F5> Enter the multi-level SSTV (slow-scan television) system. For
details on SSTV operation, see the "Slow-Scan Television"
chapter on page XX.
<F6> Places you in the function buffers screen. The function buffers
allow you to quickly send bits of information without having to
retype them during a QSO. A complete description of each of the