Instruction manual

MFJ-1289 Multicom User's Manual Page 27
QSO Time!
Once your system has been connected and configured, and the controller has
issued its "sign on" message, you're ready to begin!
After you have saved your initial program parameters to disk, you may use a
variety of keys and commands to simplify your controller's operation.
Some of the function keys in Multicom are "pre-programmed" and will always do
the same thing because they have been programmed by the software.
Other function keys are "user-programmable" and you can set them to quickly
issue commands or frequently-typed sentences to your controller, depending on
your methods of operating. A list of each key follows, along with its function.
Note: Some special functions installed in the MULTICOM software are not
useful when it is used with the MFJ-1270B or the MFJ-1274. Function keys
<F4> (FAX) and <F5> (SSTV) are not useful. Under key <F6> (mode
menu), only the <F8> key (User-Defined Function Buffers) is useful for
these controllers.