Instruction manual

MFJ-1289 Multicom User's Manual Page 24
Once the file has been created, you can load it to your TNC with the following
procedure:
1. With the controller signed on, at the command prompt (cmd:), press
<Alt> +P.
2. A screen of file(s) with the ".PRM" extension will be displayed. Highlight
the CONFIG.PRM file with the cursor keys, then press <Enter>
MULTICOM will load the CONFIG.PRM file to the controller and the
cmd: prompt will be displayed.
This file is useful for "reloading" your TNC after it loses its memory (for
example, if you disconnected the battery and reset the controller entirely).
You may edit the CONFIG.PRM file with any text editor, editing the
parameters with the information you prefer.