Instruction manual

MFJ-1289 Multicom User's Manual Page 20
Setting Up Multicom
After properly connecting the TNC to the computer and applying power to it,
change to the multicom program directory.
CD \MULTICOM <Enter> ( replace MULTICOM with the name of your
program directory)
Run the program by typing the following:
MULTICOM <Enter>
Before using Multicom for the first time, you should configure it for use by your
system. The first time you run the program, the screen below will appear
automatically. If you wish to change the configuration settings at a later time,
you may press the <F3> key from the terminal screen