Instruction manual

MFJ-1289 Multicom User's Manual Page 14
6. At this time we want to copy the files off of Disk #1. To do this you must
type the following:
COPY A:*.* C:\RADIO <ENTER>
At this point the computer will proceed to copy all Disk #1 files over to Drive C:.
The next steps will install the copy-protection over to the new directory. This must be done otherwise the
Multicom program will not run, and the software will give an ERROR MESSAGE saying:
ILLEGAL COPY !
7. With the DOS prompt of the floppy drive from which you are installing
the software still on the screen type the following:
BUILD A: C:\RADIO
At the A:\> prompt, while Disk #1 is still in drive A: type:
BUILD A: C:\RADIO <ENTER>
After the Build program has executed the Build to C:\RADIO routine, Multicom can then be used. This
same procedure can be used for any directory name that you choose, just follow the procedure very
carefully.
If at some later time you decide to uninstall Multicom from the directory specified here, use the REMOVE
procedure on Page 16. All you would need to do is substitute the directory name you used here in place of
Multicom in the example on Page 11.