Instruction manual

MFJ-1289 Multicom User's Manual Page 13
Build Procedure;
The MFJ-1289 Software has the capability to be installed in other directories
besides Multicom. This can be accomplished through the BUILD.EXE program
on Disk #1. Below is an example as to how install Multicom to another directory.
Follow the steps below to install Multicom to a directory named RADIO:
1. Obtain the DOS prompt for the hard drive to which you are going to
install the program to.
2. Ensure that you are in the root directory of your hard drive, by typing :
C:\ <ENTER>
3. Make a directory with the name desired, such as RADIO. This is done by typing the following:
MD RADIO <ENTER>
At this time the computer has made a directory named "RADIO". You are ready to install the program
into the new directory.
4. Insert the Multicom Disk #1 into the first floppy drive in your computer
system. Ensure that the Disk #1 is not write-protected.
5. Obtain the DOS prompt of the first floppy drive by typing the following:
A:\ <ENTER>
The following steps will copy the files over to our new directory named
"RADIO".