Instruction manual

MFJ-1289 Multicom User's Manual Page 12
Remove Procedure;
The original Disk #1 of Multicom allows you to install the software two (2) times
on your hard drive. If you have installed the program to a hard drive and run the
REMOVE program, the number of installation counts remaining for your
software increases by one. To uninstall, follow the procedure below, which
assumes you have previously installed Multicom onto your hard drive C: under
the subdirectory C:\MULTICOM.
1. Make backup copies of your config, parameter, pictures, text, and other
important files. You may wish to copy them to a floppy disk in case you
wish to reinstall Multicom later.
2. Insert your original Multicom disk #1 in drive A (or drive B, depending
on which drive you used to install the software). From the DOS prompt,
type:
A: <Enter>
3. At the A:> prompt, after changing your hard drive to the root directory
(C:\), type:
REMOVE C:\MULTICOM A: <Enter>
At this point, the program will remove the copy-protected software
(MULTICOM.EXE from your hard drive and place it back onto the original Disk
#1 in drive A. No other program will be copied to your floppy disk.
At the end of the REMOVE process, the software will notify you that there is
"001 [or 002] installs left" on your original disk, depending upon how many times
the software was installed. You can then install Disk #1 to your hard drive at a
later time by again using the INSTALL procedure described above.