Instruction manual

MFJ-1289 Multicom User's Manual Page 9
Hard Disk Installation
You may install Multicom onto any hard drive contained on your computer
system between C: and F:. Follow the steps below to install the software from
the floppy disk to your hard drive:
1. At the DOS prompt, select the hard drive to which you will install the
program. For example, if your hard drive is C:, then type:
C: <Enter>
2. Ensure that you are in the root directory by typing
CD \ <Enter>
3. Insert the Multicom Disk #1 in the first floppy drive of your computer
(Drive A:). Ensure the disk is not write-protected. Change to drive A:
by typing:
A: <Enter>
NOTE: If you ordered the disk size to fit your B: drive, then use the program
INSTALLB. Whenever the instructions refer to the install program (i.e.,
INSTALL C TNC), substitute INSTALLB C TNC to install from your
second drive.
4. At the A:\> prompt, while Disk #1 is still in drive A:, type:
INSTALL C <Enter>
At this point, the program will automatically install Multicom and other disk files
from Disk #1 to drive C: in the subdirectory C:\MULTICOM.