Instruction manual

MFJ-1289 Multicom User's Manual Page 8
Floppy Disk Installation
No installation is needed if you are operating the software from a floppy disk only.
Load the program as follows:
1. Boot your computer system with the DOS disk.
2. Insert the original Disk #1 (which contains the actual Multicom program
files) into your floppy drive (usually drive A: or B:).
3. At the A> or B> prompt, type
MULTICOM and press <Enter>
Note: From this point on in the manual, we will simply refer to your
computer keys by showing them in bold, <F7>. To illustrate messages from
your computer, or commands you will need to type in, we will use this
typeface. If a key needs to be "held down" while you press another key, we
will indicate it with a plus sign (for instance, <Alt> +R means to hold
down the <Alt> key and press the R key at the same time)