Service manual

EPSON LX-300+ Revision A
Disassembly and Assembly Disassembly and Assembly 68
4.2.1 Printhead Removal
1. Remove the cover and the printer.
2. Remove 1 screw (CPB, 3x14) securing the printhead to the carriage
assembly.
3. Lift the printhead a little bit. Unlatch 2 hooks securing the printhead FFC
to carriage unit.
4. Remove FFC from the printhead.
Figure4-1. Printhead Removal
CAUTION
Check if the printer is powered off before removing the
printhead.
ADJUSTM ENT
REQUIRED
When the printhead is replaced, perform the platen gap
adjustment.
Carriage Assembly
Printhead
CPB (3x14)
FFC