Service manual

EPSON LX-300+ Revision A
Disassembly and Assembly Disassembly and Assembly 67
4.2 Disassembly and Assembly
This section explains the disassembly and assembly of LX-300+. Unless
otherwise specified, assembly can be done in the reverse order of the
disassembly procedure.
Anything that service person should pay attention to is described under
“Check Point”. Any adjustment required after assembly is described under
“Adjustment”.
When you have to remove parts that are not described in this chapter, refer to
the exploded diagram on Appendix of this manual.
The figure below is the disassembly flowchart for main component.
Flowchart 4-1. Disassembly Flowchart (Main Component)
CAUTION

Read 4.1.1 "Precautions" before start disassembling the
printer.

Remove ink ribbon and paper before disassembling the
printer.
4.2.2 "Upper Housing
Removal"
4.2.1 "Printhead
Removal"
4.2.3 "Printer
Mechanism Removal"
4.2.4 "Board Assembly
and Panel Removal"
4.2.5 "C294MAIN Board
Assembly Removal"
4.2.6 "P/S Board
Assembly Removal"
START