Service manual

LX-300+ Revision A
Product Description Operation 25

Operation in default setting mode
The following switches are used in default setting mode;
1.4.1.2 LED
 Indication in normal mode
*1 Pause (Orange)
-It is on when the printer is paused, and it is off when the printer is not
paused.
-It blinks when Micro Adjust is enabled.
*2 Paper Out (Red)
-It is on when the printer is in the Paper out status, and it is off when the
printer is out of this status.
*3 Font (Green)
-The status of Font selection is displayed by 2 Font LEDs when continuous
paper is out of the Tear-off position.
-Both LEDs blink when continuous paper is in the Tear-off position.


: Draft


: Draft Condensed


: Roman

: Roman Condensed

: Sans serif


: Sans serif Condensed

: Tear Off
(

: LED On,

: LED Off,

: LED Blinks)
1.4.1.3 Buzzer
 Paper out error: Beeper sounds (...)*
 Release lever operation: Beeper sounds(-----)*
 Illegal panel operation: Beeper sounds (.)*
*The description (.) and (-) in the above shows how the beeper sounds.
(.): Beeper sounds approx. 100ms and interval is approx. 100ms.
(-): Beeper sounds approx. 500ms and interval is approx. 100ms.
Table 1-19. Operation at Power On
Switch Function
Tear Off Changes the setting.
LF/FF Selects the Menu.
The others Not available.
Table 1-20. Indication in normal mode
LED
Pause
*1
Paper
Out
*2
Font
Printer Status
Pause On --- ---
Paper out error On On ---
Release lever error On --- ---
Paper eject warning On Blink ---
Micro Adjust Blink --- ---
Tear off --- --- *3
Font selection --- --- *3
Fatal error Blink Blink Blink