Service manual

LX-300+ Revision A
Product Description Printing Specification 13
1.2.2 Paper Feeding

Feeding method: Friction feed (rear)
Push tractor feed (rear)
Push and Pull tractor feed (rear)
Pull tractor feed (rear, bottom)
 Feeder: Rear push tractor, CSF single-bin (Option),
Pull tractor (Option) and Roll paper holder (Option)
 Paper path: Manual insertion Rear in, top out
CSF Rear in, top out
Push Tractor Rear in, top out
Pull Tractor Rear or bottom in, top out
 Line spacing: 4.23mm (1/6 inch) or programmable
in increments of 0.118mm (1/216 inch)
 Feed speed: 4.23mm (1/6 inch feed) 88msec
Continuous feed 0.76MPS (m/sec)
[3.0 IPS (inches/sec)]
 Input Data Buffer: 8 Kbyte
 Release lever:
The release lever must be set according to the following table;
 Paper thickness lever:
The paper thickness lever must be set at the proper position as shown
below.
Table 1-4. Release Lever
Lever position Paper path/ Feeder Paper/ Media
Friction Manual insertion (rear) Cut sheet (Single sheet and
Multi part)
Envelop
CSF single-bin Cut sheet (Single sheet)
Roll paper holder feed (rear) Roll paper
Tractor Push tractor feed (rear) Continuous paper (Single
sheet and Multi part)
Push and Pull tractor feed
(rear)
Continuous paper (Single
sheet and Multi part)
Pull tractor feed (rear) Continuous paper (Single
sheet and Multi part)
Pull tractor feed (bottom) Continuous paper (Single
sheet and Multi part)
Labels
Table 1-5. Paper Thickness Lever
Lever
position
Paper thickness (inch)
Paper thickness (mm)
Minimum Maximum
0 (0.0024) (0.0071) over 0.06 up to 0.18
1 (0.0071) (0.0102) over 0.18 up to 0.26
2 (0.0102) (0.0130) over 0.26 up to 0.33
3 (0.0130) (0.0154) over 0.33 up to 0.39
4 (0.0154) (0.0205) over 0.39 up to 0.52
Table 1-4. Release Lever
Lever position Paper path/ Feeder Paper/ Media