Specifications

EPSON AMERICA, INC.
INFORMATION
Product Support Bulletin
Subject:
Equity LT-286e and Third Party Memory Boards
Date: 5/09/90
Page: 1 of 1
PSB No: S-011
Originator: DS
The purpose of this bulletin is to provide information on additional memory
expansion after the Epson 1mb memory bd has been installed.
Because of the 2/3 size of the AT compatible expansion slot in the LT286e, most
full length memory cards will not fit.
However, a 2/3 size 16 bit memory card from RAMFLEX has been tested and found
to be compatible.
The RAMFLEX card comes populated with 2mb of embedded DRAM. An installation
program is provided and setup is quite simple.
The RAMFLEX card must be installed as extended memory and for expanded
memory an EMS package like TURBO EMS from LANTANA must be used.
From the A: > prompt, run “INSTALL” from the RAMFLEX diskette.
The steps are self explanatory. Set the start address at 2432 if the system is already
configured at 2mb. When the system re-boots it will prompt you with a “MEMORY
SIZE ERROR” . Run setup and the memory field will auto update. System re - boots
and configures to 4mb.
LANTANA’s TURBO EMS was used to emulate 2mb of expanded memory under
LIM 4.0.
The supplier is:
COMPUTER ELEKTRONIK INFOSYS of America, Inc.
512 - A Hemadon Parkway
Herndon, VA 22070
TEL (703) 435 - 3800
(800) 322 - 3464