Operating instructions

1. Make sure the printer is turned on. If necessary, lift up the

printer cover so you can see the paper position.

2. Load either continuous or single-sheet paper. (Press the

Load/Eject

button to load continuous paper or a single-sheet

from the optional cut-sheet feeder.)

3. Hold down the

Pa use

button for about three seconds. The

Pa u se

light starts flashing and the printer enters the

micro-adjust mode.

4. Press the

LF/ FF

[

] button to move the loading position down

on the page, or press the

Lo a d / Eje c t

[

] button to move the

loading position up on the page.

Note:

❏ The printer has a minimum and a maximum loading position. If you

try to adjust the loading position beyond these limits, the printer

beeps and stops moving the paper.

❏ When the paper reaches the factory-set loading position, the printer

beeps and paper feeding pauses briefly. Use the factory setting as a

reference point when adjusting the loading position.

A41

Adonis Rev.C

A5 size Chapter 3

96/ 12/ 19 pass 5

3-28

Paper Handling