User`s manual
TM-L90 with Peeler User’s Manual 7
English
8. When using the label continuous issuing mode (not using the peeler), close
the peeler cover now. When using the peeler (the label peeler issuing mode),
pass the paper through the peeler, and close the peeler cover.
9. Press the PAPER FEED button. The paper is automatically fed backward, and
the
PAPER OUT LED goes off.
Note:
If you open the roll paper cover with roll
paper installed, make sure to open the
peeler cover first, and then the roll paper
cover. If you open them in the reverse
order, the roll paper can get trapped under
the roll paper cover when it is closed,
causing a possible paper jam. When
closing the roll paper cover, make sure to
close it firmly, pressing both ends.
While a label is being issued, do not touch
it until the PAPER OUT LED starts
flashing. Pulling it before that may result
in the waste of a label.
Do not block the label peeler detector with your fingers, or anything else while the label
issuing is in progress. This may cause the printer to feed the following label.
label peeler issuing mode label continuous issuing mode