Product specifications

3-4 Connecting to the Host Computer and Options Rev. C
Connection procedure
1. Press the connector on the end of the interface cable firmly onto the interface connector
located on the connector panel.
2. When using connectors equipped with screws, use the screws to tighten the connectors
firmly in place.
Tightening Screws
3. For interface cables equipped with a ground line, attach the ground line to the screw hole
marked "FG" on the printer.
4. Connect the other end of the interface cable to the host computer.
3.2.2 With the Parallel (IEEE1284) Interface
TM printer is connected to the host PC via parallel port mounting parallel interface board
(UB-P02II). DM-D is connected to the host PC via serial port.
Xon/Xoff
(except OPOS)
DTR/DSR
(DOS, Windows
(only OPOS))
RTS/CTR
(DOS, Windows (hardware
control: Windows driver))
Xon/Xoff Not available — —
DTR/DSR 1 — Type A or B Type B
2 — Type A or B Type A or B
Application
control
TM side
control setting