Product specifications

Rev. C Setup 2-37
TM-L90/TM-L90 with Peeler Technical Reference Guide
2.9.2 TM-L90 Peeler Specification Memory Switch Settings
Among the settings shown below, some can be set with the memory switch setting mode. Refer
to page 2-26.
Msw 1-7, 1-8 are effective only when serial interface is used.
MSW1
Bit Function 0 (OFF) 1 (ON) Initial setting
1 Send power on notification Not sent Sent OFF
2 Select receive buffer capacity Large (4K bytes) Small (45 bytes) OFF
3 Conditions for Busy status Receive buffer full or
offline
Receive buffer full OFF
4 Data processing when
reception error occurs
Substitute with "?" Ignored OFF
5 Automatic line feed Invalid Valid OFF
6 Reserved Fixed — OFF
7 #6 pin: Select reset signal Not used Used OFF
8 #25 pin: Select reset signal Not used Used OFF
MSW2
Bit Function 0 (OFF) 1 (ON) Initial setting
1 Reserved -- Fixed to 1 (ON) (do not
change setting)
ON
2Reserved -- -- ON
3-8 Reserved OFF fixed OFF
MSW7
Bit Function 0 (OFF) 1 (ON) Initial setting
1-7 Reserved -- -- OFF
8 FEED button operational
settings (applied only during
printing with continuous
issuing)
Moves the paper to the
next printing start position
Pressing FEED once moves
the paper to the manual
cutter position.Pressing FEED
twice moves the paper to
the next label printing start
position.Thereafter, pressing
FEED repeats the operation
above.
OFF