Product specifications

Rev. C Setup 2-21
TM-L90/TM-L90 with Peeler Technical Reference Guide
DIP switch settings (Serial interface model)
bps: Indicates the number of bits transferred per second.
DIP switches 2 to 8 are for serial communication. Not used in parallel communication.
Note:
When you set the baud rate with the memory switch, you can set faster communication than with the DIP
switch. (Refer to “Communication Condition” on page 2-28, “Error Code” on page F-3)
In serial communication, intermittent printing* may occur. This is because when the communication
speed is low, a data transmission waiting state occurs frequently since the printing mechanism speed is
high. Increasing the communication speed may reduce this symptom.
* Intermittent printing: White streaks as large as one or two hairs appear horizontally in a printing result.
DIP switch settings (Parallel, USB, Ethernet model)
bps: Indicates the number of bits transferred per second.
DIP switches 2 to 8 are for serial communication. Not used in parallel communication.
SW No. Function ON OFF Initial Setting
1 Enable/disable Power
switch.
Switches power supply On/
Off using commands.
(Power supply switch is
disabled.)
Power supply switch is used
to switch power On/Off.
OFF
2 Select for serial
communication condition.
Set using DIP switch 1-7, 1-8 Set using memory switches. ON
3 Handshake XON/XOFF DTR/DSR OFF
4 Bit length 7 bits 8 bits OFF
5 Parity check Yes No OFF
6 Parity type Even Odd OFF
7 Baud rate (bps) 7 8
ON ON :2400
OFF ON :4800
ON OFF :9600
OFF OFF :19200
OFF
8 OFF
SW No. Function ON OFF Initial Setting
1 Enable/disable Power
switch.
Switches power supply On/
Off using commands.
(Power supply switch is
disabled.)
Power supply switch is used
to switch power On/Off.
OFF
2 Reserved Fixed to on -- ON
3 Reserved -- Fixed to off OFF
4 Reserved -- Fixed to off OFF
5 Reserved -- Fixed to off OFF
6 Reserved -- Fixed to off OFF
7 Reserved -- Fixed to off OFF
8 Reserved -- Fixed to off OFF