Product specifications

Rev. C Setup 2-19
TM-L90/TM-L90 with Peeler Technical Reference Guide
4. Push the roll paper spacer until it clicks.
Note:
Check that the roll paper spacer slides smoothly from side to side.
5. Slide the roll paper spacer side-to-side and set it to the appropriate position. Use the
measurement lines if necessary.
Note:
Roll paper is placed on the tab-free side of the roll paper spacer.
When positioning the roll paper spacer, provide 0.5 mm of room for the maximum roll paper width.
6. Secure the roll paper spacer with the supplied screw. (See above.)
7. Set the paper width using any of various drivers, the memory setup utility or the memory
switch setting mode.
(For the memory switch setting mode, refer to “Setting Memory Switches” on page 2-22.
screw
measurement