Product specifications

Rev. C Consumable Specifications B-21
TM-L90/TM-L90 with Peeler Technical Reference Guide
B.2.2.10 Requirements for black mark position I
The black mark positions on the paper to be manufactured must meet the requirements in the
figure below. The reflective rates of the black mark portions 1 and label portions 2 must meet the
combinations shown in the table below (the reflective rate is measured using the back of the
paper, the non-printing side):
NOTE:Reflective rates are measured by the Macbeth PCM-II (Filter D) meter.
B.2.2.11 Requirements for Black Mark Position II
The black mark positions on the paper to be manufactured must meet the requirements in the
figure below (the reflective rate is measured using the back of the paper, the non-printing side):
❏ Black mark length in vertical: 4 ~ 7.5 mm {0.157~ 0.295"}
❏ Black mark position: Any places
NOTE:Reflective rates are measured by the Macbeth PCM-II (Filter D) meter.
If label paper meets Black Mark Position Requirement I, it is not necessary to consider Black Mark Position
Requirement II.
Reflecting rate for black mark portion 1 17% 16% 15% 14% 13% Less
Reflecting rate for label portion 2 90% 85% 80% 75% 70% More
Reflecting rate of black mark portion (1) 17% 16% 15% 14% 13% Less
Reflecting rate of the portion where the
black mark does not exist (2)
90% 85% 80% 75% 70% More