Product specifications

B-18 Consumable Specifications Rev. C
B.2.2.4 Paper to use for high speed
If any of the following original paper types of thermal paper are used, the memory switch for
the customized value setting can be used to set the maximum print speed up to 150 mm/s
{5.91"/s} (level 9); however when the peeling issuing mode is selected, set the maximum print
speed to 120 mm/s or less.
B.2.2.5 If paper other than the specified original paper is used
If paper other than the specified paper is used, confirm whether the paper meets the
requirements for the thickness, the peeling strength, and the transparency rates.
B.2.2.6 Requirements for die-cut label paper thickness, peeling strength, and adhesive
agent
Requirements for the thickness of the die-cut label paper, peeling strength against backing
paper, and the adhesive agent that can be used with the printer are shown in the figure below:
Die-Cut Label Paper Thickness, Peeling Strength, and Adhesive Agent
Peeling strength of the label against backing paper, measured by FINAT FTM-1 (Europe), ASTM D3330/D3330M-02
(U.S.A.).
Note:
❏ Total of thermal paper and backing paper: 145 µm or less (excluding adhesive agent)
❏ Adhesive agent: acrylic emulsion