Product specifications

Rev. C Consumable Specifications B-9
TM-L90/TM-L90 with Peeler Technical Reference Guide
B.1.2.9 Requirements for die-cut label paper thickness, peeling strength, and adhesive
agent
Requirements for the thickness of the die-cut label paper, peeling strength against backing
paper, and the adhesive agent that can be used with the printer are shown in the figure below:
Die-Cut Label Paper Thickness, Peeling Strength, and Adhesive Agent
Peeling strength of the label against backing paper, measured by FINAT FTM-1 (Europe), ASTM D3330/D3330M-02
(U.S.A.).
Note:
❏ Total of thermal paper and backing paper: 145 µm or less (excluding adhesive agent)
❏ Adhesive agent: acrylic emulsion
B.1.2.10 Requirements for black mark position for die-cut label paper
If die-cut label with black marks is used, there are two reflective rate requirements, depending
on the size and position of black marks. Be sure to use label paper that meets either black mark
position requirement I or II as follows: