Specifications

Rev. A Adjustments and Settings 2-9
TM-J7000/TM-J7100 Developer’s Guide
Confidential
Operating procedure
The procedures used for this process are described below.
Entering Memory Switch Setting Mode
Selecting Items to Set
Selecting Individual Settings
Ending Memory Switch Setting Mode
❒ 1 time: Autocutter
❒ 3 times: Basic Serial Interface Settings
❒ 4 times: Advanced Interface Settings
❒ 6 times: Interface Reset Signal
Autocutter
(page 2-10)
Basic Serial Interface
Advanced
Interface
Setting
(page 2-10)
Automatic
Line Feed
(page 2-11)
Interface reset
signal
(page 2-12)
Open the roll paper cover.
Press the FEED button the number of times required to select the desired item (as shown below);
then close the roll paper cover.
Pressing the paper FEED button 0 times or 7 or more times and then cloxing the cover will
terminate this procedure.
Open the roll paper cover.
Press the FEED button the number of times required to select the setting for each item; then
close the paper roll cover.
Baud Rate Setup
(page 2-10)
❒ 0 times:
❒ 2 times:
❒ 7 or more times: Unused
1. Open the roll paper cover and turn the power on while pressing the paper FEED button until
POWER, ERROR, and PAPER OUT LED are on.
2. Press the paper FEED button twice while POWER, ERROR, and PAPER OUT LED are on.
3. Close the roll paper cover.
4. Press the paper FEED button.
The printer prints the current settings and setting instructions.
The printer prints the new settings and saves the settings to NV memory. Then, the printer is reset
and enter the normal printable status. Begin using the printer or turn the power supply OFF.
Data Length,
Handshake, or Parity
(page 2-11)