Specifications

2-4 Adjustments and Settings Rev. A
Confidential
Transmission Speed
bps: bits per second
Note:
Changes in DIP switch settings are recognized only when the printer power is turned on or when the
printer is reset by using the interface. If a DIP switch setting is changed after the printer power is turned
on, the change does not take effect until the printer is turned on again or is reset.
DIP Switch Settings for Parallel Interface specifications
Memory Switches
The printer unit has the following memory switches in NV memory.
• Memory switches: MSW1, MSW2, MSW8
• Customized value
• Serial communication conditions
These settings can be set by using the ESC/POS command GS ( E, or the Memory Switch Setting
Utility. For detail of the ESC/POS command, see the ESC/POS Application Programming
Guide. For details about the utility, see the user’s manual for the utility.
Some of these settings also can be set by panel operation (Memory switch setting mode). (See
“Memory switch setting mode” on page 7.)
Msw 1 is defined as follows:
Transmission speed (bps) SW1-7 SW1-8
9600 On On
19200 Off On
38400 On Off
115200 Off Off
SW 1 Function On Off
1 ~ 8 Reserved -- Fixed to Off