Specifications

Rev. A Adjustments and Settings 2-3
TM-J7000/TM-J7100 Developer’s Guide
Confidential
3. Be sure that the sensor lever operates smoothly after setting.
Note:
If the roll paper becomes loose due to the paper quality, the near-end sensor may operate incorrectly.
DIP Switches
The DIP switches are located on the main board inside the bottom cover of the printer.
DIP Switch Settings for Serial Interface Specifications
SW 1 Function On Off
1 Reserved -- Fixed to Off
2 Interface condition selection By DIP switch By memory switch
3 Handshaking XON/XOFF control DTR/DSR control
4 Word length 7 bits 8 bits
5 Parity check Yes No
6 Parity selection Even Odd
7
Transmission speed selection
See the following table “Transmission
Speed.”
8
DIP switch