User`s manual

Printer Parts
DIP Switch Tables
ERROR
PAPER
OUT
POWER
FEED
5 paper roll
control pane
l
4 paper roll cover
6 slip paper
control panel
2 front cover
1 on/off switch
3 autocutter cover
POWER
FORWARD
ERROR
RELEASE
SLIP
REVERSE RELEASE
Serial
SW Function ON OFF
1-1 Data receive error Ignored Prints “?”
1-2 Receive buffer 45 bytes 4 KB
1-3 Handshaking XON/XOFF DTR/DSR
1-4 Data word length 7 bits 8 bits
1-5 Parity check Enabled
1-6 Parity selection Even
1-7 See “Transmission speed” table.
1-8
SW Function ON OFF
2-1 Handshaking Buffer full Offline or buffer full
2-2 Customer
display
Connected Not connected
2-3, 2-4 Print density See “Print density” table.
2-5, 2-6 Reserved. Do not change. Fixed to OFF.
2-7 Pin 6 reset Enabled Disabled
2-8 Pin 25 reset Enabled Disabled
Serial transmission speed
1-7 1-8 Speed
ON ON 2400 bps
OFF ON 4800 bps
ON OFF 9600 bps
OFF OFF 19200 bps
Print density
2-3 2-4 Density
ON ON Low power mode
OFF OFF 1 (normal)
ON OFF 2
OFF ON 3 (dark)
Parallel
SW Function ON OFF
1-1 Auto line feed Enabled Disabled
1-2 Receive buffer 45 bytes 4 KB
1-3 ~ 1-8 Undefined — —
SW Function ON OFF
2-1 Handshaking Buffer full Offline or
buffer full
2-2 Reserved
Do not change.
Fixed to OFF.
2-3, 2-4 Print density See “Print density” table.
2-5 ~ 2-7 Reserved. Fixed to OFF. Do not change.
2-8 Pin 31 reset Fixed to ON.