User`s manual

SECTION III.
After creating the PFT and saving,
return to the DW4 main menu
and enter the PROFILES menu. Select the newly
for the Printer Function Table
created GQ3500 PFT
Complete and
exit
(Refer to DW4 users manual).
the PROFILES section
Proceed to SECTION IV.
saving
changes made.
SECTION IV.
This section deals with selection of the PAGE PRINTER MODE.
The dip switches are located on the GQ3500 interface board.
the
To access these switches, loosen the two thumbscrews and pull
I/F board out firmly.
The switch settings are as follows:
DIP SWITCH l-l
OFF
1-2 OFF
The other DIP switches can be left in the factory settings for
most applications.
information.
Refer to the GQ-3500
IMPORTANT NOTES
FORMAT ERRORS
While this function table will work
attempts to format a page will
with most commands some
result in
DW4.
These
should not
an error display from
cause
concern
unless
the printing is
incorrect.
In that case, verify the
be printed before modifying the PFT.
commands in the document to
USERS MANUAL for more
FONT CARDS
If you have font cards these can be selected using the
Typestyles/ Character
Set Group Definitions. The "ESC y" command
must first select the appropriate
then
residing in
that card
slot,
the desired font
font no.
(e. g. 1B 79 01 00 will select slot no. 1
1). The hex commands needed are outlined in the GQ-3500
USER'S MANUAL.
DOWNLOADED FONTS
Once the fonts
selectable using
are downloaded to the GQ-3500 they are
the "ESC %"
command
Character Set Group Definitions.
from the Typestyles/
MANUAL for more information.
Refer to the GQ-3500 USER'S