User`s manual

3. Press the SHIFT button once. The status indicator on the control
panel displays a blinking dot to show that the printer is in
SelecType mode.
In the SelecType mode, the left character in the STATUS indicator
indicates the function and the right character indicates an option
within that function.
If you have set your DIP switches for letter size paper, the
STATUS indicator displays 05 when you first enter SelecType.
As you
can see on the function table, function 0 is paper size and option 5 is
letter (LT).
The 05, therefore, indicates that letter size paper has been
selected.
Selecting functions
When you are in SelecType, the FUNCTION 1 button selects
functions and the FUNCTION 2 button selects the options.
To select functions and options in SelecType, follow these steps:
1.
Press the FUNCTION 1 button to select the function you want. Each
time you press the button, you advance the left character by one
digit, from 0 through 9 to A and then back to 0 again. As the
function selections change, the option settings change to reflect the
different options in effect for the different functions.
Don’t worry if you pass the selection you want. Just keep pressing
the button until it comes up again.
If you hold down the
FUNCTION 1 button, the digits keep changing until you let it up.
2. After you have selected the function you want, press the
FUNCTION 2 button to select an option within that function.
Options that are not possible are not displayed in the status
indicator.
When an option selected by software is not available in SelecType
for the current function, the right position displays three
horizontal bars ( 3 ) instead of a number or letter. For example, if a
software command has set the printer for ten copies and you select
function 1 (MULTI COPY), the three bars display on the status
indicator because 1 through 9 are the only options for this function
in SelecType.
-
3-2
SelecType