Instruction manual
Table Of Contents
- Front Matter
- Contents
- Introduction
- Chapter 1: Setting Up the Printer
- Chapter 2: Using Paper and Other Media
- Chapter 3: Printing with EPSON Drivers for Macintosh
- Chapter 4: Printing with EPSON Drivers for Windows
- Chapter 5: Maintaining and Transporting the Printer
- Chapter 6: Resolving Problems
- Appendix A: Specifications
- Index
2-22
2-22 | Using Paper and Other Media
7. Push the paper set lever all the way in, then close the lower cover.
PRESS PAUSE BUTTON
appears on the control panel display.
8. Press the
Pause
button. The print head moves and the board feeds into
printing position automatically.
READY
appears on the control panel.
(Even if you don’t press
Pause
, the board and printer will move into
printing position automatically after 10 seconds.)
9. Run your print job. After it is finished, the posterboard stays in the
printer.
10. To remove the print, hold it while pulling the paper set lever out to the
released position.
Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light
is flashing.
Note
If print quality is not
satisfactory, you may
need to adjust the platen
gap. See page 2-25.