Instruction manual

1-7
Setting Up the Printer | 1-7
6. Remove any packing tape from the printer. Be sure to check underneath
and on the sides.
7. Open the front cover and remove the wing screw and washer from the
print head. Save these parts in case you need to ship the printer.
8. Close the front cover.
9. Raise the stabilizer knobs and unlock the casters. Then move the printer
to its place of use. (The casters are meant for moving the printer only
over a short distance.) Lock the casters and extend the stabilizer knobs
after moving.
Note
When choosing a place
for the printer, leave
adequate room for easy
access and ventilation.
Avoid locations subject to
direct sunlight, excessive
heat, moisture, or dust.
Also avoid locations near
potential sources of
interference, such as loud
speakers, cordless
phones, TVs, or air
conditioners.