Specifications

Close the rear cover (make sure the paper separator is flat on the printer), open the guide wire,
and close the access cover (5).
Turn the printer on. The printhead will move and the control panel will light up. The ALARM light
will also come on. Pull the bail lever forward (6). The paper will automatically feed into the printer
and the ALARM light will go out. If paper doesn't feed, check to make sure that the paper lever is
in the forward position.
- Do not use the Form Feed button to load paper.
Push the bail lever back to close the bail (8).
Adjust the top of form (see page 13( )), then press the
SEL
button ( the SEL light will go on)
and you're ready to print.
ML 320/321 ( 96-02-01 )