Specifications

Install/Replace The Ribbon Cartridge

The printhead can get very hot during extended periods of printing be sure to let it cool off

before you touch it. Be sure the power is off before you move the printhead.

Open the access cover. Position the printhead between the bail rollers (7). Make sure the

bail is closed (bail lever toward back of printer).

Install/Replace the Ribbon Cartridge

ÎBe sure to use only ribbons specifically for MICROLINE 320/321 or MICROLINE 100 Series

printers. Ribbon cartridges for ML390/391 printers look similar, but they will not fit in the ML320/321.

For best result use genuine OKIDATA ribbons, part number 52102001.

If you're replacing the ribbon cartridge, swing the front of the cartridge up off the printhead, then

lift the cartridge out and discard it. Hold the new ribbon cartridge with the knob facing up and the

flat end toward the front of the printer. Place the flat end into the ribbon plate(8) then lower the

front of the cartridge over the printhead until it snaps into place (9). Turn the knob in the direction

of the arrow to take up the slack in the ribbon.

ML 320/321 ( 96-02-01 )