Specifications

Setting Top of Form

Note: Make sure the paper is held in place by the bail. If the top of the page is set below the

bail, paper will catch on the bail and cause a jam. The amount you can move the paper down

using this method is limited to avoid potential paper jams.

Make sure the printer is deselected. Hold down the

TOF/QUIET

button and press:

FORM FEED

to move the paper up, or

LINE FEED

to move the paper down.

This moves the paper in 0.007 increments. The lower red line on the paper shield shows

the baseline of the current printing position to help you place the top of form.

When the top of form is set where you want it, the position is recorded permanently in

the printers memory even when the printer is turned off until you reset it.

Note:

If youre using continuous forms, you can temporarily change the setting to another

location without disturbing your normal setting.

- To do this, first make sure the printer is deselected (press the

SEL

button if its not).

- Then press the

LINE FEED

button (without holding down the

TOF/QUIET

button)

to move the paper to the new location you want to set for the top of form.

- Once youve positioned the paper where you want it, press the

TOF/QUIET

button to

engage the location as your temporary top of form.

The printer will retain this temporary setting until its turned off. To restore your normal

top of form setting, turn the printer off and then on again.

ML 320/321 ( 96-02-01 )