User`s manual

2-1
Section 2 Specifications
2-1 Specifications
2-1-1 General specifications
Items
S pecification s
NP5M0101-2S4/ 2L4, NP5N0011-2S4/ 2L4
Physical
env ironmental
con dition s
Operational ambient
temperature
0to+50
o
C
Storage ambient
temperature
-10to+60
o
C
Operational ambient
h u m idity
85% RH or less
(Without dew condensation, max. wet-bulb temperature: 39 or less)
Operational altitude 2000m or less above sea level (Transport condition: 70kPa or more)
Operational atmosphere No corrosive gas, no ex cessive dust, no conductive dust contamination, and no
t
stained with organic solvents.
Pollu tion degree 2 (Note1)
Mechanical
working
con dition s
Vibration resistance Half-amplitude: 0.075mm, acceleration: 9.8m/s
2
,
X, Y, Z: 3 di rections for one hour
Shock resistance Peak acceleration: 147m/s
2
,X,Y,Z:3directionsthreetimeseach
Electrical
working
con dition s
Noise resistance Ri sing time: 1ns, pulse width: 1µs, Noise voltage: 1.5kVp-p
(Measured by using a noise simulator.)
Static electricity
discharge resistance
Contact: 4kV, air: 8kV
Power supply Rated input voltage 24V DC (Note2)
Rated voltage (tolerance) 24V DC 10%
Permi ssi ble momen tary
power failure
1ms or less
power supply consumption
(Max. rated)
27W or less
Rush current 167A or less
Input termi nal block
Di splay u ni t Terminal block screw: M3.5
Tightening torque: 1.2N·m
Controller unit T erminal block screw: M3
Tightening torque: 0.5 to 0.6N·m
NDielectric strength 500V AC 1 minute (Between external term inals and frame groun d)
Isolation resistance 500V DC, 5MW or more
Di mensions W x H x D (mm) 182.5 x 138.8 x 81.0
Mass Approx . 1.34kg
Note 1) Pollution degree 2: This pollution does not conduct usually, but under certain circumstances temporary
conductivity occurs due to condensation.
Note 2) Use 24V DC power supply which comply to UL standard Class2 insulation.
- Installation specifications
Item S pecification s
Grounding Less than 100W, FG/SG separated
Protection structure Front panel (Note 1) Compliant with IP65 (When using waterproof gasket) (Note 2)
Cooling system Cooling naturally
Structure Inserted in a mounting panel
Appropriate m ounting panel thickness
@E.Termin al
1.5to5mm
Note 1) Protection structure for the front when the @E.Terminal is mounted on the mounting panel.
Note 2) It is recommended to use the mounting panel whose thickness (steel, stainless) is 2.0 mm or more to keep the
unit compliant with IP65. The strength differs depending on the material of the mounting panel. Check the
environment where the @E.Terminal is used.