Service manual

Document # 720000-0000
May 2008
17
EZ LOAD PRINTER
Service
Manual
4 Media and Supplies Guide
4.1 Thermal Paper Specifications
The printer requires qualified thermal paper with the following dimensions:
4.1.1 EZload H/W rev.1
Table 11: Paper specs EZLoad rev1
4.1.2 EZload H/W rev.2
Table 12: Paper specs EZLoad rev2
4.1.3 EZload Stretch
Table 13: Paper specs EZLoad stretch
The paper should not be attached to the core. If Top of Form Option is installed, paper with a
colored stripe at the end can be used to indicate that the paper is running low.
Width Diameter Outside Core Diameter
80 mm ± .2 mm (3.15 in. ± .008 in.) 115 mm max. (4.5 in.) 45mm (1.75 inches)
82.5 mm ± .2 mm (3.25 in. ± .008 in.) 115 mm max. (4.5 in.) 45mm (1.75 inches)
Width Diameter Outside Core Diameter
80 mm ± .2 mm (3.15 in. ± .008 in.) 125 mm max. (5 in.) 45mm (1.75 inches)
82.5 mm ± .2 mm (3.25 in. ± .008 in.) 125 mm max. (5 in.) 45mm (1.75 inches)
Width Diameter Outside Core Diameter
80 mm ± .2 mm (3.15 in. ± .008 in.) 152 mm max. (6 in.) 45mm (1.75 inches)
82.5 mm ± .2 mm (3.25 in. ± .008 in.) 152 mm max. (6 in.) 45mm (1.75 inches)