Service manual

Document # 720000-0000
May 2008
9
EZ LOAD PRINTER
Service
Manual
2.5 Testing the Printer
Run this test to check the printer. The test prints and cuts a resident test ticket. Verify this ticket
to judge the printing quality.
Figure 10: Status ticket
To print the test ticket, power-on the printer while pressing and holding the Paper Feed Button
for approximately 3 seconds. A test ticket similar to above will be printed approximately 5
seconds after. Press the paper feed button once more and the ticket will feed. Pressing the
button again will result in blank tickets.
Model: EZLOAD
Firmware: EZL-3.66J (0x75E6)
Protocol: Axiohm A722
COMMUNICATION
Interface: Serial
Baud: 19200
Data Bits: 8
Parity: NONE
Handshaking: PRT+RTS
Print Mode: Line
Aux Port: Disabled
PRINT CONTROL
Print Method No HPQ
Speed: 125 mm/s
Black Bar Index: Disabled
No HPQ Burn Time: 425 us
Cutter PWM 80%
Motor Current: 2
Real Time command: Enabled
Validation Bit: After TOF detect
PRINTER ENVIRONMENT CONDITIONS
Voltage: 24.2 Volts
Temperature: 26 Celcius
SYSTEM RESOURCES
FLASH: Used=00000 RAM Used=00000
Free=65535 Free=65535
LIBRARY INVENTORY (STANDARD)
Templates: 0,1,2,3,4,5,6,7,8,9,A,B,F
Print Regions: 1,2,3,4,5,6,7,8,9,A,B,C
D,E,F,G,H,I,J,K,L,N,O,P,Q,R
S,T,U,Z,X,a,b,c,d,e,f,g,i
J,k,l,m,n,o,p,q,r,s,t,u,v,w
Fonts: 0,1,2,3,4,5,6,7,8,9,A,B,E,P
Graphics:
MANUFACTURING INFORMATION
Printer ID: 5465789
Date Code: 20184
A to D: DE7AA400FD000000
EZL-3.66j | @ | @ | @ | H | @ | P | *