Operation Manual

8. Insert paper cassette 2.

Check the paper size and paper type settings displayed on the control panel. To use the settings, press

Conrm. To change the settings, press Change, and then go to the next step.

Note:

e

paper setting screen is not displayed if you have disabled Paper

Conguration

in the following menus.

Setup > Printer Setup > Paper Source Setting > Paper

Conguration

10. Select the paper size and then select the paper type on the next screen.

11.

Check the paper settings you selected, and then press Done.

Note:

❏ You can also display the paper size and paper type settings screen by selecting the paper source in the following

menus.

Setup > Printer Setup > Paper Source Setting > Paper Setup

❏ e output tray slides out automatically when printing starts. To eject the tray before printing starts, press the

button.

Related Information

& “Paper Handling Precautions” on page 21

& “Available Paper and Capacities” on page 22

“Menu Options for Paper and Print Settings” on page 53

Loading Paper in the Rear Paper Feed Slot

You can load a single sheet of all types of supported paper in the rear paper feed slot. You can also load thick paper

(up to 0.6 mm thick) and pre-punched paper, which cannot be loaded in the paper cassette. However, even if the

thickness is within this range, some paper may not be fed correctly depending on the hardness.

Important:

Do not load paper in the rear paper feed slot until the printer prompts you to do so. Doing so will result in the blank

paper being ejected.

1. Do one of the following.

❏ When printing from the control panel: Select rear paper feed slot as the Paper Source setting, make other

print settings, and then press the

button.

User's Guide

Loading Paper